Note: the error "ERROR: CVideoPlayer::OpenInputStream - error opening " was resolved by making the folder: Note: kodi -> Add-ons -> My add-ons -> PVR clients -> Tvheadend HTSP Client -> Configure Sudo apt install kodi-pvr-mythtv kodi-pvr-vuplus kodi-pvr-vdr-vnsi kodi-pvr-njoy kodi-pvr-nextpvr kodi-pvr-mediaportal-tvserver kodi-pvr-tvheadend-hts kodi-pvr-dvbviewer kodi-pvr-argustv kodi-pvr-iptvsimple kodi-audioencoder-vorbis kodi-audioencoder-flac kodi-audioencoder-lame Note: recommended programs were installed:
Note: make sure the Tvheadend -> Configuration -> DVB Inputs -> Services. note: read and select the proper OTA and/or cable network(s) for your location Kodi (note: kodi should now open but will not have any TV channels) cx231xx 1-1.4:1.1: Cx231xx dvb Extension initialized dvbdev: DVB: registering new adapter (cx231xx #0) Note: the steps below will verify that the Hauppauge WinTV-HVR-955Q is present:īus 001 Device 004: ID 2040:b123 Hauppauge Exiting")Ĭd /lib/firmware (note: the two fw files were installed for the Hauppauge WinTV-HVR-955Q - perhaps only one may have been needed) G2 GL (Fake KMS) OpenGL desktop driver with fake KMS (note: this resolved the kodi "ERROR: Unable to create GUI.
The RPi4 used was NOT a clean Raspbian Buster installation, so there may be some differences with a clean installation due to other software packages previously installed. The steps below used were in the shell as user pi. My recommendation is to read all the links above before starting since Kodi and Tvheadend can be complex. Hauppauge WinTV-HVR-955Q for USA ATSC OTA (over-the-air) and cable Kodi 18.4-Leia was installed on a RPi4 "Raspbian GNU/Linux 10 (buster)" with the following hardware and software:
0 kommentar(er)
